-
Sectoral shares of primary and secondary particulate matter in total emissions, EEA-32
-
The graph includes the combined emissions of primary PM10 particles (particulate matter with a diameter of 10 μm or less, emitted directly into the atmosphere) and secondary particulate-forming pollutants (the fraction of sulphur dioxide, SO2, nitrogen oxides NOx and ammonia NH3 which, as a result of photo-chemical reactions in the atmosphere, transform into particulate matter with a diameter of 10μm or less). Emissions of the secondary particulate precursor species are weighted by a particle formation factor prior to aggregation: primary PM10 = 1, SO2 = 0.54, NOx = 0.88, and (NH3) = 0.64.
Located in
Data and maps
›
Maps and graphs
-
Emissions intensity of carbon dioxide from public conventional thermal power production
-
Emissions intensity is calculated as the amount of pollutant produced (in tonnes) from public electricity and heat production divided by the output of electricity and heat (in toe) from these plants.
Located in
Data and maps
›
Maps and graphs
-
Changes (%) in emissions of acidifying pollutants by source category, 1990-2007, EEA-27 (weighted by acid equivalency factors)
-
The figure shows the emissions of acidifying pollutants (sulphur dioxide SO2, nitrogen oxides NOx and ammonia NH3) each weighted by an acid equivalency factor prior to aggregation to represent their respective acidification potentials. The acid equivalency factors are given by: w(SO2) = 2/64 acid eq/g = 31.25 acid eq/kg, w(NOx) = 1/46 acid eq/g = 21.74 acid eq/kg and w(NH3) = 1/17 acid eq/g = 58.82 acid eq/kg.
Located in
Data and maps
›
Maps and graphs
-
Variation of CO2 emissions in transport (EU-27)
-
CO2 emissions for total transport can be split into 2 explanatory effects: an activity effet illustared by an increase in traffic of passengers and freight, CO2 savings due to the reduction in the specific emissions of vehicles per unit of traffic
Located in
Data and maps
›
Maps and graphs
-
Emissions intensity of nitrogen oxides from public conventional thermal power production
-
Emissions intensity is calculated as the amount of pollutant produced (in tonnes) from public electricity and heat production divided by the output of electricity and heat (in toe) from these plants.
Located in
Data and maps
›
Maps and graphs
-
Observed global fossil fuel CO2 emissions compared with six scenarios from the IPCC
-
IPCC scenarios shown are from the IPCC Special Report on Emissions Scenarios (IPCC, 2000). Past emission data are from the Carbon Dioxide Information and Analysis Center (CDIAC) and the International Energy Agency (IEA)
Located in
Data and maps
›
Maps and graphs
-
Annual European Community greenhouse gas inventory 1990-2004 and inventory report 2006
-
Located in
Publications
-
New maps give Europeans close-up picture of air pollution from diffuse sources
-
New online maps published today by the European Commission and the European Environment Agency, in close cooperation with the Institute for Environment and Sustainability (IES) of the Joint Research Centre, allow citizens to pinpoint the main diffuse sources of air pollution, such as transport and aviation. The new set of 32 maps shows where certain pollutants such as nitrogen oxides and particulate matter are released. It complements existing data on emissions from individual industrial plants from the European Pollutant Release and Transfer Register (E-PRTR). The Europe-wide register aims to help Europeans actively engage in decisions affecting the environment.
Located in
Press room
›
News
-
Net imports of all fossil fuels and CO2 emissions in EU-27 by fuel and origin of the fuel, 2008
-
Net imports of all fossil fuels and CO2 emissions in EU-27 by fuel and origin of the fuel, 2008
Located in
Data and maps
›
Maps and graphs
-
Air pollution - key fact 5
-
Only 14 European countries expect to comply with all four pollutant-specific emission ceilings set under EU and international legislation for 2010.
Located in
The European environment – state and outlook 2010
›
…
›
Air pollution — SOER 2010 thematic assessment
›
Key facts